Fastback II Edge Polisher with Conveyor and Tooling (for Granite and Stone Fabrication)

This Fastback II Edge Polisher with Conveyor and Tooling was involved in an insurance claim and is being sold by the insurance company to recover part of their loss.

Condition:

This precision machinery was dropped during offloading. The unit was a couple feet above the warehouse floor and the machine slid off the forklift.

• The electrical panel would need to be replaced due to the damage.
• The drive motor and gearbox would need to be replaced due to the damage.
• The conveyor frame looks twisted.
• The control panel may have sustained damage due to the shock of the drop.
• The spindles could potentially have some damage due to the shock of the drop.
• The frame of the machine would need to be reviewed since it may be bent.
The Fastback II Edge Polisher utilizes intuitive controls:
• Color Touchscreen Controls
• Tool Life Monitoring
• Polish Offset Pro
• Automated Water Control
• Automated Water Shutoff
• Manual Spindle Pressure Adjustment
• Remote Diagnostics
Single pass, load-and-go automation:
• FAST Production: 18 - 30"+ per minute single pass performance
• Vertical flat edge polish from 1 cm to 6 cm thick material
• 45 degree chamfer top and bottom edge corners (removes chips from sawing)
• Piece length: 16" to 12'
• Piece height: 3" to 30" (taller stones possible with operator assistance)
Note: Bid acceptance is pending seller's review. Seller has the right to reject all bids. This bid make take over 1 week after auction closing for acceptance as it must be reviewed by the seller. If you have not met the reserve, but have the top bid, your bid may still be accepted. Salvex will negotiate with the seller, so please standby to see if your offer is accepted.